Last update: 2008-10-17
Clearance Items
Discount prices on unused products from PROJECT H2.
Project H2 is cleaning house! Clearance parts listed are already discontinued items. Get them while you can! This special is for customers in the USA only
This reproduction item was produced by Mr. Shirayama from Osaka Mach Club. The Rear Hub Damper Rubber Set is compatible with all KAWASAKI 500 H1 models (KA, H1,KH500)
We have only two H1 Rear Hub Damper Rubber Sets in stock.
The Rear Hub Damper Rubber Set including 6 damper rubbers (the picture is incorrect),
| Product ID | Name | Price | Order Page |
|---|---|---|---|
| PHOT1400-51A | Rear Hub Damper Rubber Set | 86.00 USD | |
| pd-sp081017a | Rear Hub Damper Rubber Set | 52.00 USD |  |
This gear was produced by a member of Mach Club (Japan). The gear material is the same as genuine gears.
We have only four gears in stock.
| Product ID | Name | Price | Order Page |
|---|---|---|---|
| PHOT**** | Distributor Gear | 18.00 USD | |
| pd-sp081017b | Distributor Geart | 9.00 USD | |
The Cylinder Stud Bolt Set is a reproduction part that is produced by POP Minami (Osaka Mach Club). The Stud Bolt Set including 12 stud bolts and special thread compound (used during installation).
We have only four sets in stock.
| Product ID | Name | Price | Order Page |
|---|---|---|---|
| PHOT**** | Cylinder Stud Bolt Set | 87.00 USD | |
| pd-sp081017c | Cylinder Stud Bolt Set | 54.00 USD | Sold Out |
When Project H2 first manufactured its first lot of cables, several were pulled for shop use and future testing. These remaining cables are of the same quality as all other cables sold previously. They are new and unused.
The short throttle cables can be used on a H2 that has been modified with low handle bars. The height of the handle bars that can be installed are from 76 - 100 mm. It is not possible to use the short cables for a handle bar higher than 100 mm.
For use with a stock 750 H2 models VM carburetors (it can not be use after market VM type carburetors)
We have only four cables in stock.
| Product ID | Name | Price | Order Page |
|---|---|---|---|
| PHOT1015-0017 | H2 Short Throttle Cable for Stock H2 Carburetor | 54.00 USD | |
| pd-sp081017d | H2 Short Throttle Cable for Stock H2 Carburetor | 44.00 USD | |
This cable is compatible only with Flat Slide type carburetor (MIKUNI TM, KEIHIN PWK, PJ).
We have only eight cables in stock.
| Product ID | Name | Price | Order Page |
|---|---|---|---|
| PHOT1015-0018 | H2 Short Throttle Cable for Flat slide carbu | 54.00 USD | |
| pd-sp081017f | H2 Short Throttle Cable for Flat slide carbur | 44.00 USD | |
